Table of Contents
Advertisement
Installation
4.4.3 Configure the Robot as an Adapter
To access the communication settings Expert or Specialist protection level is needed.
To change the protection level press the
The default password is 12345.
Now the Fieldbus can be initialized.
Go to Constant setting > Communication > Fieldbus.
Select the EtherNet/IP card installed in your robot controller for Channel 1
AnyBusEtherNet/IP).
NOTE:
The AnyBus EtherNet/IP card can be mapped into other Channel than the
first, but in this case OR_init(...,fieldbusCH) needs to be set
accordingly. For more information about the channels please see the FD
CONTROLLER INSTRUCTION MANUAL EtherNet/IP Function – (TFDEN-
122-005_EtherNetIP.pdf / Chapter 3.1.x).
button then enter 314 and press
(Enter) button.
(in this case
30
Advertisement
Table of Contents
