Table of Contents
Advertisement
User Access Settings
In the User Access Settings screen, FTP and File Share access can be turned on or off
independently.
Simply turn either FTP or File Share to ON to enable either or both of
these features.
If either feature is turned on, a User Name and Password must be assigned. If not
User Name or Password is assigned, that resource must be turned off.
Note: There are no password length or character restrictions. It is best practice to
utilize strong passwords (ones over 8 characters in length and with a mix of letters,
numbers and special characters).
Connect the Ethernet cable
Connect a Standard RJ45 CAT5e or better Ethernet cable to the Ethernet port
marked NETWORK on the right left side next to the USB ports. If the cable is
connected correctly, the green LINK LED directly above the cable port will turn ON.
If the green LED is not ON, check the cable polarity, cable continuity or network
connection.
Connecting to Instant Replay using FTP
Supported FTP Clients
Instant Replay includes an RFC-1359 compliant FTP server. Most commercially
available FTP clients should work with Instant Replay.
Example of Connecting DOS FTP
1. From a Windows PC, open a DOS Shell as follows.
Press Windows Key + r to open a run prompt and type cmd and click OK.
2. From the command prompt, type
ftp <IP ADDRESS>
...where the IP ADDRESS is the address you set your Instant Replay to in the Initial
Setup step. For example 192.168.1.120 would be a valid entry. The display will do the
"dots" for you.
2. Type in USER ID when Prompted.
3. Type in the PASSWORD when prompted.
Instant Replay 3 Operations Manual
Page 73
Advertisement
Table of Contents
