Playing A Hot-List; Clear A Hot-List; Play A Clip Using The Rear-Panel Gpi; Pausing A Playing Clip - 360 Systems INSTANT REPLAY 3 Operation Manual

Playing a Hot-List

Once a Hot List is created, pressing Hot List and then Play will start playout.
Note that the playout of a Hot List will follow the FOLLOW ON mode. When
FOLLOW ON is on, clips will playout in sequence one after the other automatically.
When FOLLOW ON is off (MANUAL), clips will stop at the end and wait for PLAY to
be pushed to start the next clip.
While playing a Hot List, subsequent presses of PLAY will skip to the next clip in the
Hot List and start playout.

Clear a Hot-List

Since Hot Lists are set on a per Bank basis, to clear a Hot List, go to the main menu
and BANK MANAGER.
In the Bank Manager, select the Bank that has the Hot List that is to be cleared.
Select CLEAR HOT LIST and then OK to clear the Hot List.

Play a Clip Using the rear-panel GPI

Instant Replay includes six General Purpose Interface (GPI) that can be set to Play,
Pause, Stop, Record or Loop. See the section on setting up the GPIO for additional
information.
When a remote momentary switch assigned to a GPI with the Play function is
pressed, the Instant Replay will behave as if PLAY had pressed.

Pausing a Playing Clip

Press PAUSE to interrupt playback of a clip.
Press PLAY to resume playback.

RECORDING A CLIP

Note that when making recordings the resulting file is in the .wav format. The
maximum recording length of a file is restricted to 90 minutes.
NOTE: The Balanced and Unbalanced analog inputs are mixed together. It is not
recommended that both be connected at the same time, unless one or the other is
muted.
Instant Replay 3 Operations Manual Page 57