Electrical Power - 360 Systems INSTANT REPLAY 3 Operation Manual

Connecting Input Sources
Connect Balanced stereo analog sources to the BALANCED INPUT stereo pair.
Connect Unbalanced stereo analog sources to the UNBALANCED IN stereo pair.
Note: These inputs are mixed together internally and are both active whenever the
AUDIO Input is set to ANALOG.
Connect a digital AES/EBU source to the AES/EBU DIGITAL IN connection.
Connect a digital IEC-958 RCA source to the IEC-958 II RCA jack.
Connect a PoE (Power Over Ethernet) switch cable to the Dante module if it exists.
The input source used for recording is selected via the Record Settings in the main
menu.
Connecting Monitoring Equipment
Connect Balanced stereo analog monitors to the BALANCED OUTPUT stereo pair.
Connect Unbalanced stereo analog monitors to the UNBALANCED OUT stereo pair.
Connect a digital AES/EBU monitor to the AES/EBU DIGITAL OUT connection.
Connect standard stereo headphones to the ¼" headphones jack.
Note: Audio will be played on all outputs at all times with one exception. When the
PREVIEW key is lit, audio will be played only to the headphone output.

ELECTRICAL POWER

ONLY A 360 SYSTEMS APPROVED POWER SUPPLY SHOULD BE USED WITH THIS
SYSTEM. FAILURE TO USE A PROPERLY RATED POWER SUPPLY MAY CAUSE DAMAGE
TO THE SYSTEM. CONNECT THIS PRODUCT ONLY TO AN AC POWER SOURCE WITHIN
THE VOLTAGE AND FREQUENCY RANGE INDICATED ON THE POWER SUPPLY. THE
PRODUCT IS SUPPLIED WITH A DETACHABLE IEC TYPE AC LINE CORD APPROPRIATE
TO THE COUNTRY TO WHICH THE UNIT WAS ORIGINALLY DELIVERED. CHECK TO SEE
THAT IT MATCHES THE ELECTRICAL OUTLET YOU WILL BE USING.
REPLACE POWER CORD ONLY WITH UNDERWRITERS LABORATORIES (UL) LISTED CORD
Power Button
The power button is located on the front panel.
Instant Replay 3 Operations Manual
CAUTION!
WARNING:
OF EQUIVALENT TYPE AND RATING!
Page 49