Sleep And Active Mode; Replacement Parts; Labels; Safety Warnings - Datacolor CHECK II Quick Start Manual

Sleep and Active Mode

To conserve the internal battery power, both the instrument and the
PDA are programmed to timeout, or go into Sleep mode when no
activity is detected over a specified time period.
The Sleep function is controlled separately for each component. As a
result, the instrument can remain active (―awake‖) while the PDA is
asleep, and the PDA can remain active (―awake‖) while the instrument is
asleep.

Replacement Parts

This instrument uses high voltage during operation, and should only be
serviced by qualified personnel.

Labels

There are several labels on the unit including the following.
The WARNING symbol indicates that the user should refer to the
documentation before using the instrument.
Datacolor CHECK II instrument model and serial number.

Safety Warnings

Light Source. Do not stare directly into the open port located at the
bottom of the instrument, when a measurement is in progress. Staring
directly into the light source can result in eye discomfort similar to that of
staring at a camera flash.
CAUTIONS
(1) Disconnect all power before servicing.
(2) The power cord supplied must be used.
(3) There are no user serviceable parts for this system.

Instrument Maintenance

There are no user-serviceable parts for this equipment.
6  General Information
CHECK II Quick Start Guide