Storing And Retrieving Samples - Datacolor CHECK II Quick Start Manual

Naming Samples before Measurement
To name a Standard before measuring, do the following:
1.
2.
3.
4.
5.
To name a batch before measuring:

Press the Measure/Select Batch
and repeat the procedure.
Naming Samples after the Measurement
Sample names can be edited at any time. See Datacolor CHECK II
User's Guide, for detailed instructions.

Storing and Retrieving Samples

Autosave is the default condition and every measurement is stored, in
the folder that is currently selected. All batch measurements are
attached to the standard that is active at the time of the measurement.
CHECK II Quick Start Guide
Press the Measure/Select Standard button
of the Control Panel.
Activate the cursor on the name line by touching the line.
Tap the abc or 123 icon in the graffiti pad to display the
keyboard, and enter a name.
Tap the Close icon in the bottom right corner to close the
keyboard.
Place the stapler foot over the sample, and press the
Measure button. The name you entered will be displayed
for the standard.
on far left
on the Control Panel,
Measuring Samples  27