Table of Contents
Advertisement
Calibration Data
If the calibration data is deleted from the instrument, or if you received a
replacement calibration tile, you must install the white tile data. This
requires the data CD. See Datacolor Portables Program, Installing
White Tile Data for detailed instructions to install this data.
WARNING
If you have changed the white calibration tile, you must install the
measurements for the new tile you are using. If you do not, the
instrument calibration and any measurements made are not valid.
General Information
Operation
This product is to be used only in a manner specified by the
manufacturer, and according to the instructions for operation and
maintenance provided herein.
If the equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
Power Source
The unit must be used with the power adapter or lithium ion batteries,
provided only by Datacolor.
Power adapter (Datacolor part no. 4050-0065) has a maximum output of
6.5 volts DC, 1.5 amps.
The power cord supplied must be used.
Replaceable lithium ion batteries (Datacolor part. no. 1200-1299) are
the only batteries compatible with Datacolor CHECK II.
other rechargeable or non-rechargeable batteries.
The battery is fully charged before it leaves the factory. However, it
may lose some of its charge by the time it arrives at your location.
Connect
you receive the unit. See "Instrument Cable" for instructions on how to
attach the power adapter to the unit.
Running from Power Adapter
Whenever Datacolor CHECK II is connected to the power adapter, it
automatically recharges the battery at the same time it is providing
power to the unit. You can make measurements while the battery is
recharging. When the battery is totally discharged, it takes
approximately 4 hours to fully recharge it.
4 General Information
the Datacolor CHECK II to the power adapter as soon as
Do not use any
CHECK II Quick Start Guide
Advertisement
Table of Contents
