Datacolor CHECK II Quick Start Manual page 35

Active Standard. The standard used in the current evaluation. When
you select a different standard, no color differences will be displayed
until you select a batch.
Active Batch. The batch used in the current evaluation. When you
select a different batch, the data displayed are based on the new batch
selection.
NOTE
You can only display the evaluation data for one batch at a time.
Illuminant/Observer. Identifies the Illuminant and Standard Observer
data used for the evaluation displayed.
Next Sample Type. This identifies the sample type, standard or batch,
to be assigned to the next measurement.
Next sample will be labeled a standard.
Next sample will be labeled a batch.
You can override this assignment by pressing the Select/Measure
Standard or Select/Measure Batch buttons on the Control Panel.
Gloss Compensation Enabled. The evaluation is based on
measurements corrected for gloss differences (when disabled this icon
does not display).
Strength Adjustment Enabled. The evaluation is based on a batch
measurement that has been adjusted for strength (when disabled this
icon does not display).
Batch Specular Std Specular. The specular port settings
(SCI/SCE/Gloss) for the standard and the batch must be the same in
order for the color evaluation to be valid. When the specular port
selection for both samples is not the same, this icon displays as a
warning that the evaluation displayed is not valid.
Performing Color Evaluations  31
CHECK II Quick Start Guide