Christie Mirage 304K Installation And Setup Manual page 29

5. To focus the bottom boresight guide, adjust the blue boresight screw.
Adjust the screw 1/4 turn. If you get to the end, further unlock the corresponding stabilization
screw.
6. To focus the right boresight guide, adjust the green boresight screw.
7. To focus the left boresight guide, adjust the yellow boresight screw.
8. To continue to refine the focus, repeat steps 5 to 7.
9. Before adjusting the stabilization screws, close the shutter.
10. To maintain the adjustments, lock the stabilization screws.
When locking the screws, start with the top stabilization screw and turn it so it just touches the
base. Repeat for the other two stabilization screws. Continue to adjust the locking screws until
they are tight.
11. Open the shutter.
Mirage 304K (Bm.1) Installation and Setup Guide
020-102013-12 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
29