Selecting Panoramic Exposure Program - Planmeca ProOne User Manual

9.2 Selecting panoramic exposure program

User's Manual
You can set the X-ray unit so that the estimated DAP
(Dose Area Product) value will be shown on the main
display for the exposure you are going to take. The DAP
value indicates the highest radiation dose the patient will
be exposed to during the exposure. Refer to section
14.2.2 "Program presets (P2200)" on page 84 for more
information.
You can set the X-ray unit so that the actual DAP (Dose
Area Product) value will be shown on the display after
each exposure. The actual DAP value indicates the actual
radiation dose the patient was exposed to during the
exposure. Refer to section14.2.3 "Functions after
exposure (P2300)" on page 86 for more information.
You can set the X-ray unit so that a preview of the image
will be shown on the control panel after exposure. This
option allows you to evaluate the image immediately after
you have taken it. Refer to section14.2.3 "Functions after
exposure (P2300)" on page 86 for more information.
NOTE
The control panel can be adjusted to respond to your
individual finger touch. Refer to section 14.1.3
"Operational settings (U1300)" on page 76 for more
information.
NOTE
You can switch practice mode on if you wish to practice or
demonstrate the functions of the X-ray unit without
radiation. Refer to section14.1.3 "Operational settings
(U1300)" on page 76 for more information.
To select a panoramic exposure program, touch the
program field on the main display. The main display is the
display that is shown when the X-ray unit is switched on.
9 CONTROL PANEL
Planmeca ProOne 15