Run Encoder Test - Viavi AVX-10K Operation Manual
Flight line test set
Hide thumbs
Also See for AVX-10K:
- Operation manual (267 pages) ,
- Getting started manual (21 pages) ,
- Getting started manual (17 pages)
Table of Contents
Advertisement
After test completion, you can select the XPDR Config Check button to display specific decoded
transponder configuration settings to ensure proper setup of the transponder under test. This is a
beneficial tool for user verification of transponder configuration. For transponder configured fields,
the AVX-10K only displays the decoded data and cannot determine PASS/FAIL criteria for these fields.
Note: In the test results, the nomenclature ITM refers to "Intermode". Intermode is
when a Mode A or C Interrogation is tested along with a Mode S Interrogation. See
Appendix A for more details on XPDR Auto Test Results.
4.1.2.1
Run Encoder Test
To capture altitude results with a faster interrogation rate, expand the A/C Decoder SLS ribbon, press
the RUN button and select LOOP EXPANDED TEST. Press the RUN button then at the bottom of the
Rev. 002
22135254
VIAVI
AVX-10K Operation
2022-08-25
Page
69
of
139
Advertisement
Table of Contents
