Direct To Uut; Common Setup Parameters - Viavi AVX-10K Operation Manual

3.1.3.

Direct to UUT

On occasion, the AVX-10K may need to be directly connected to the UUT bypassing the antenna and
cabling. When using this setup, only the cable loss will factor into the setup parameters.
3.2.

Common Setup Parameters

There are settings that are duplicated across many applications within the AVX-10K. This section will
detail those common settings of applicable test applications from the SETUP tab. These include:
• "RF Port" (Antenna, Direct Connect, Direct Connect with Coupler)
• "Antenna Settings" (Range, Height, Gain [1.03 GHz, 1.09 GHz])
• "Cable Settings" (Cable Length, Cable Loss)
• "Coupler Settings"
"UUT Address"
•
"Position Settings" (Entry Method, Latitude, Longitude, Format)
•
"Advanced Settings" (Check All UUT Capability, Verify Unit Setup Configuration)
•
Rev. 002
22135254 VIAVI
AVX-10K Operation
2022-08-25
Page 49 of 139