Run Tcas Scenario - Viavi AVX-10K Operation Manual

The main screen of the TCAS application also has a number of configurable parameters. These
configurable fields have a blue background.
Setting
Scenario
TCAS Type
Intruder Type
Range Start (nm)
Range Stop (nm)
Range Rate (kts)
Reply (%)
Rate Enable
Converge
Altitude Detect
Altitude Rate (fpm)
Altitude Direction
Altitude Start
Altitude Stop
Aircraft Baro Test
Altitude
5.1.2.

Run TCAS Scenario

This application will allow you to set up one dynamic intruder for TCAS testing. You can select from
one of the provided scenarios listed or create one of your own and save it as a custom scenario for
later recall. Any of the fields with a blue background are editable.
Rev. 002
22135254
Allows for selection of predefined scenarios and a provision for
saving custom scenarios. When one of the predefined scenarios are
selected, all the following parameters will be loaded with values.
Select between TAS, TCAS I or TCAS II to emulate
Toggles between ATCRBS and MODE S type of transponder to
emulate
Enter a value between 0 and 260 nautical miles
Enter a value between 0 and 260 nautical miles
Enter a value between 0 and 1200 knots (closure rate)
Enter a value between 0 and 100% for reply rate
Toggles between STOP and RESUME
Toggles between OFF and ON.
Toggles between OFF and ON. This can be used to bypass the
Aircraft Baro Test Altitude entry below which will be disabled when
this is set to ON. In that case, the altitude of the unit under test
(UUT) is obtained from the squitter information.
NOTE: This information will be available when testing over-the-air.
When using a TCAS Coupler, the TCAS may not be able to get
information from the Transponder. Obviously, this is not the case
when testing combined TCAS/Transponder UUTs.
Enter a value between 0 and 10000 feet per minute
Toggles between UP and DOWN
Enter a value between -1000 and 126700 feet
Enter a value between -1000 and 126700 feet
Enter a value between -1000 and 126700 feet. This is the altitude of
the UUT and must match in order for targets to be painted.
VIAVI
Description
AVX-10K Operation
2022-08-25
Page 83 of 139