Table of Contents
Advertisement
English
4.4
Select a transmitter
Identify the transmitter you want to use. Make sure the
transmitter is fully charged by placing it in the charger
and checking that the light on the charger is solid green.
See SECTION 8.4 for details about charging the transmit-
ter.
CAUTION
• If the transmitter is not fully charged, the app will display
a message at the start of the session, that lets you know
the transmitter might not last for the full 14-day session.
You cannot switch transmitters in the middle of a session.
If the transmitter battery dies, you will need to insert a new
sensor to start a new session.
• Check the transmitter for any visible defects, such as
cracks. Do not use the transmitter if you see any defects.
4.5
Activate the transmitter
Although you can connect multiple transmitters to the
app, only one transmitter can send CGM readings to the
app at a time. That transmitter is referred to as the active
transmitter.
See SECTION 8.6 how to activate a transmitter.
4.6
Place the transmitter into the
sensor assembly
To complete these steps, you will need the active tran-
smitter and the sensor assembly.
14
1.
Remove the sensor assembly from
the sterile pouch.
2.
Remove the sensor assembly from
the inner tray.
CAUTION
Do not peel off the protective paper on the sensor assem-
bly until immediately before insertion.
3.
Set the sensor assembly on a hard, clean surface (such as the inside of
the sterile pouch) with the sensor adhesive patch facing down.
A
A
4.
Locate the transmitter arms (B).
B
B
Advertisement
Table of Contents
