Frequently Asked Questions - Philips AVENT SCD841 Manual

Frequently asked questions

HOW TO USE / CONNECTING THE UNITS
Question
Why does the power-on
light of the baby unit not
go on when I switch on
the unit?
Why doesn't the parent
unit charge when I plug
it in?
Why doesn't the baby
unit charge when I plug
it in?
Why can't I establish a
connection?
Why is the connection
lost every now and then?
Why are there sound
interruptions?
What happens during a
power failure?
This chapter summarizes the most common problems you could
encounter with the appliance� If you are unable to solve the problem
with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your
country�
Answer
Perhaps the baby unit is not connected to the mains� Connect the baby
unit to the mains. Then set the on/off switch of the baby unit upwards to
the ON position to establish connection with the parent unit�
Perhaps the adapter is not plugged in properly� Make sure the adapter is
plugged into the wall socket properly�
The parent unit may already be fully charged� The battery status light will
be green when the battery is fully charged and the device is connected to
the mains power�
The baby unit does not have a charging function� The baby unit only
works when it is connected to the mains.
The baby unit and the parent unit are probably close to the outer limits
of the operating range or there is interference from other 2.4 GHz
wireless devices. Try a different location, decrease the distance between
the units or switch off other 2.4 GHz wireless devices (laptops, mobile
phones, microwaves, etc) . It can take up to 10 seconds before the
connection between the units is reestablished�
If the signal is lost, then the parent unit will make a beeping sound
(3 quick beeps every 20 seconds).
The baby and parent unit might be too close to each other, keep them at
least 1�5 meters/ 5 feet away from each other to prevent interference�
As the parent unit works on a rechargeable battery, the parent unit
continues to work if the battery is sufficiently charged. However, the
baby unit stops working because it has no rechargeable battery and only
works on a mains power� The parent unit will give a beeping sound to
indicate that the link with the baby unit is lost�
When mains power is restored, the connection between the parent unit
and the baby unit will automatically be established�
- English 29 -