Warranty And Support; Frequently Asked Questions - Philips AVENT SCD831 Manual

Warranty and support

Frequently asked questions

HOW TO USE / CONNECTING THE UNITS
Question
Why does the power-on
light of the baby unit not
go on when I switch on
the unit?
Why doesn't the parent
unit charge when I plug
it in?
Why doesn't the baby
unit charge when I plug
it in?
6 Remove the 4 screws from the battery holder� No screws for new
versions manufactured after August 2020�
7 Remove the battery�
*The production date code DDMMYY is located underneath the belt clip,
above the 2 rubber feet�
If there is no collection/recycling system for electronic products in your
country, you can protect the environment by removing and recycling the
battery before disposing the product�
Make sure the product is disconnected from the charging case before
removing the battery�
If you need information or support, please visit www.philips.com/
support or read the international warranty leaflet.
This chapter summarizes the most common problems you could
encounter with the appliance� If you are unable to solve the problem
with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your
country�
Answer
Perhaps the baby unit is not connected to the mains� Connect the baby
unit to the mains. Then set the on/off switch of the baby unit upwards to
the ON position to establish connection with the parent unit�
Perhaps the adapter is not plugged in properly� Make sure the adapter is
plugged into the wall socket properly�
The parent unit may already be fully charged� The battery status light will
be green when the battery is fully charged and the device is connected to
the mains power�
The baby unit does not have a charging function� The baby unit only
works when it is connected to the mains.
- English 23 -