Philips AVENT SCD841 Manual page 32

HOW TO USE / CONNECTING THE UNITS
Why can the charging
time of the parent unit
exceed 3 hours?
Why do I need to keep
the baby unit and its cord
at least 1 meter/ 3�5 feet
away from my baby?
What is the difference
between the various user
modes on the parent
unit: Video, Audio, VOX
and ECO?
The parent unit may be switched on during charging. Switch off the
parent unit during charging to reduce the charging time� When the
display of the parent unit is constantly on, charging of the parent unit will
take more time�
Perhaps temperature has exceeded the charging tolerance that could
potentially cut off the charging circuit as a safety protection mechanism.
To resume charging, move the charging station away from any heat
sources such as radiators, heat registers, stove or other appliances
(including amplifiers) that produce heat.
To avoid strangulation with the cord and for optimal sound detection,
always place the baby unit and its cord at least 1 meter / 3�5 feet away
from the baby�
See below list for an explanation on the available modes on your baby
monitor�
* Video mode: the screen and sound of the parent unit are always on.
* Audio mode: only audio will be activated. The display of the parent unit
switches off when AUDIO mode is activated. The link light shows that
the parent unit is still on and connected to the baby unit� The sound level
lights above the screen will light up green when sound from the baby
unit is heard� All normal correspondence with the baby unit is possible via
the talk back, lullaby, menu and sensitivity buttons.
* VOX mode: The display and sound of the parent unit switch off if there
is no sound detected for 20 seconds (or not enough sound above the
sensitivity setting)� Both display and sound will be activated immediately
when your baby cries and the sensitivity threshold is passed� When the
sound drops below the sound threshold, the video will remain active for
20 seconds� When one of the control buttons is pressed (brightness or
volume), the device shall display video for roughly 5 seconds. Also the
lullaby menu is accessible�
* ECO mode: The display and sound of the parent unit switch off
when no sound is detected for 20 seconds� Eco Mode reduces power
consumption during quiet times while keeping you connected to your
baby� In ECO mode the ECO LED light is green and the device will operate
on a different connection modus. In ECO mode the parent unit uses the
2 seconds ping mechanism to check the connection with the baby unit
instead of a continuous radio frequency connection� Therefore the Baby
Unit will also consume less energy in ECO mode�
- English 30 -