Barazza 1FEVGVC Instruction Manual page 27

installed, this must be done in the shaded
area.
• The unit in which the oven is installed and
adjacent units
temperatures higher than 85 ºC.
• The installation instructions must be ad-
hered to strictly. If not, the oven's
ventilation circuit may become blocked,
causing high temperatures that could
damage the
appliance itself.
• For
this purpose,
measurements and those of the holes to
be drilled in the units, as shown in the
following figures:
Column Installation:
must withstand
kitchen unit and
check the
Undercounter Installation:
Electrical connection
The fitter must ensure that:
• The mains power voltage and frequency
correspond to what is marked on the
the
identification plate.
• The
unit
withstand the maximum power marked on
the identification plate.
• After connecting the power supply, check
that all electrical parts of the oven are
working correctly.
Oven installation
For all ovens. After the electrical connection
has been done:
1. Position the oven inside the unit and
ensure that the feed cable is not trapped
or in contact with parts of the oven that
heat up.
2. Make sure that the body of the oven is not
in contact with the walls of the unit and that
there is a minimum space of 2 mm
between adjacent units.
3. Centre the oven in the unit so that there is
a minimum space of 5mm between the
oven and the doors of the furniture that
surrounds it.
27
domestic wiring system can