Barazza 1FEVGVC Instruction Manual page 23

Assembling the supports
3. Insert the rear notch into the rear fastening
nut.
4. Fix the front fastening nut (C) in the front
notch of the support.
5. Secure the support with the nut (D) and
turn until it is fully adjusted (E).
WARNING! Failure to secure tightly the
support with the nuts may lead to
overheating and damages.
Cleaning the oven door
Dismantling/assembling the interior glass
of the door
WARNING! If dismantling the glass panes
with the door fitted in the oven, always do
it with the hinge in the locked position. If
not, the door will close and the unmounted
glass panes could break and cause injury.
Depending on the model, your oven may have
1 or 3 panes of glass. Follow the instructions
for the type of door your oven has.
1. Using your fingers, press the buttons
located at the top of both sides of the oven
door.
2. Keep them pressed and pull on the plastic
seal above the door.
3. Remove the glass panes from the door.
Clean them with a glass cleaner or soap
and water and a soft cloth.
WARNING! Pay attention to the order and
position of the glass panes when removing
them as they must be reassembled in the
same order and position when you have
finished cleaning them.
4. Once clean, insert pane no. 3 into the
same position so that the TERMOGLASS
indication printed on it is visible as shown
in following image.
5. Reattach the top seal of the door, making
sure that the side tabs fit into their
housings.
WARNING! Never switch the oven on if any
of the glass panes on the door are missing.
23
EN