Table of Contents
Advertisement
Every 250 hours - sprayer pressure gauge
±
WARNING! The hose may be subject to residual pressure and cause liquid splatter. To avoid all risk of accidental
splashing, wear protective goggles and gloves.
The pressure gauge may no longer display the pressure with sufficient accuracy. This may be due to clogging of the hose
connecting it to the liquid system.
In this case, you can dismantle the pressure gauge to rinse the hose.
1. Push the ring fig.1 and remove the hose.
2. Spray clean water to rinse the pressure gauge hose.
3. Reconnect the pressure gauge by simply pushing the hose into
the connector.
Every 500 hours - brake system hydraulic filter
To replace the filter cartridge:
• Unscrew the filter housing fig.1.
• Remove the filter cartridge fig.2 and replace it with a new one.
±
WARNING! It is essential to use an original filter.
Every 500 hours - hydraulic filters in the tank
±
WARNING! Before replacing the filters, wear protective gloves to avoid the oil making any contact with the skin.
€
DANGER! Hot oil can cause serious burns.
±
WARNING! It is essential to use an original filter.
The filters elements should be fitted on either side of the tank. They
should always be replaced at the same time.
A drip pan should be put in place to collect the used oil contained in the
filter housing. A valve at the end of the filter housing retains the oil from
the tank.
6 - Maintenance
1
2
1
85
Advertisement
Table of Contents
