Table of Contents
Advertisement
6 - Maintenance
Every 10 hours - Cyclone filter
To check the filter:
1. Close the suction and pressure valves.
2. Unscrew top (A).
3. Remove the top and strainer (B) from the body of the filter.
4. Remove the strainer from its built-in support in the top and
clean it.
To re-assemble:
1. Grease the two gaskets in the top. Given the limited space,
it is easier to use a toothbrush.
2. Replace the strainer in its support (which should not be greased).
IMPORTANT! Do not put the strainer in its support the wrong way
round. If you do, it will not engage correctly.
3. Replace the assembly in the body of the filter and tighten the top all the way.
±
WARNING! Before you open the filter, put on gloves and protective clothing.
€
DANGER! The suction and pressure valves must always be closed before opening the Cyclone filter. Otherwise,
when opening the top, there is a risk of splashing or the main tank emptying.
Every 10 hours - Brakes (optional)
Press the brake pedal and check the operation of the sprayer's brakes.
Every 50 hours - Transmission shaft
Check the state and operation of the transmission shaft guards. Replace any defective part.
Every 50 hours - Tyre pressure
Check the tyre pressure against the table in the "Technical Specifications" section.
€
DANGER! Never inflate tyres to a pressure greater than that indicated in the table. There is a risk of over-inflated tyres
exploding and causing serious personal injury. See the section "Occasional maintenance - Replacing tyres".
±
WARNING! If you replace tyres, check that the new ones have the necessary load index.
Every 250 hours - Wheel nuts and bolts
Tighten studs and bolts to the following torque:
Hub studs on the wheel disc: 490 Nm.
Tightening order: Follow the numbering sequence in the illustration
opposite.
IMPORTANT! After fitting or tightening the wheels, put the plastic
covers back on the bolts.
58
Advertisement
Table of Contents
