Hardi ALPHA evo ALU-TWIN FORCE Instruction Book page 57

Rinsing
• Turn the Smartvalve suction valve to the position shown in the
picture.
• Hold the container upside down over the multi-hole nozzle and
press the control lever fig.3.
• Close the TurboFiller lid again and press the TurboFiller rinse
control lever fig.4.
• Close the TurboFiller suction valve fig.1 after rinsing the TurboFiller.
• When the spray liquid is well mixed, turn the SmartValves as shown
in the picture.
• Keep the pump working to continue agitation in the tank.
±
Before positioning the SmartValve pressure pump in the
[TRANSFER] position, it is important to check that the transfer connector plug has been screwed in correctly and is
completely closed. If this is not the case, there is a risk of contamination and injury from the effect of the pressure if
the plug is not correctly in place. If the plug is not completely tight, lubricate the seal and the thread.
÷
For the TurboFiller gauge reading to be reliable, the sprayer must must be on flat ground. For more precision, use a
calibration jug.
µ
Before using the container rinsing lever, hold the container or flask over the multi-hole nozzle to avoid any risk of the
liquid splashing.
µ
The container rinsing device uses the liquid. Use clean water to rinse containers several times before disposing of
them.
µ
Carefully clean the inside of the TurboFiller with clean water at the end of the spraying job.
5- Operation
55