Table of Contents
Advertisement
6 - Maintenance
Every 50 working hours – Transmission shaft, chassis, air pressure and diaphragm pump
Check the condition of the transmission shaft protection guard. Replace any damaged parts as required.
Re-tighten the bolts of the wheels and the areas under the greatest stress or torque.
Check/adjust tyre pressure.
Check/adjust pressure in pump pressure pulsation damper.
Grease the diaphragm pump.
Every 100 working hours – Drawbar
Grease the drawbar or ball of the mistblower.
Check that the pivoting axles are not blocked or deformed.
Grease and oil all moveable parts.
Every 250 working hours – Wheels, brakes, hoses and gearbox
Check and grease the hub and the wheel braking system.
Verify the hydraulic brake.
Check all the hoses in the circuit.
Check the gearbox support and re-tighten the bolts holding it in place.
Every 1000 working hours – Full service
Perform a full service on all the parts described previously.
Change the gearbox oil.
Dismantle and grease the transmission shaft and joints going through the main tank.
Dismantle the fan clutch and clean/lubricate.
Every 1000 working hours - Gearbox oil change
Change the oil after the fi rst 150 working hours then every 1000 working
hours or once a year - whichever comes fi rst.
Run the mistblower until the gearbox has reached normal operating
temperature before draining the oil.
Clean the pump and area around dip stick, and drain plug before
changing the oil
Fill with Fresh oil until the level reaches the level hole (B) Capacity:
Approximately 1.25 litres.
A. For Oil fi lling (SAE 90)
B. Oil Level indicator
88
A
B
Advertisement
Table of Contents
