Engine Lubricating Oil - Hardi ALPHA EVO II EcoDrive Instruction Book

Engine Lubricating Oil

Regulation for working on lubrication of oil
±
Do not work when the engine is running! Smoking and naked lights prohibited! Be careful of hot lubricating oil.
Danger of scalding!
÷
Pay attention to utmost cleanliness when working on the lubricating oil system. Clean the area around the
components concerned carefully. Blow damp parts dry with compressed air. Observe the safety regulations and
national specifications for handling lube oils. Dispose of leaking lubricating oil and filter elements properly. Do not
allow used oil to seep away into the ground. Perform a trial run after all work. Pay attention to tightness and
lubricating oil pressure and then check the engine oil level.
Draining of lubricating oil
• Warm up the engine (lubricating oil temperature > 80 °C).
• Ensure that the engine or vehicle is in a level position.
• Switch off the engine.
• Place a collecting receptacle underneath the lube oil drain screw.
• Unscrew the lube oil drain screw, drain oil.
• Turn in and tighten lubricating oil drain plug fitted with new
sealing ring.
• Pour in lube oil
– Quality/viscosity data and filling volume. See "Suitable
Lubricants" page 141.
Tightening torque 55 Nm
• Warm up the engine (lubricating oil temperature > 80 °C).
• Ensure that the engine or vehicle is in a level position.
• Check lubricating oil level, if necessary top up.
• Confirm the lubricating oil change
- Reset the hour counter
Change lubricating oil cartridge
• Loosen and unscrew filter with a tool
• Collect draining lubricating oil
• Clean the sealing surface of the filter support with a lint-free, clean
cloth.
• Oil the gasket of the new DEUTZ original filter cartridge lightly.
• Screw on new filter by hand until the gasket is touching and
tighten with a torque of: 15-17 Nm
• Fasten clamps of the twist protection (optional).
÷
NOTE! It is essential to use genuine filters.
÷
Incorrect operation can cause damage to the engine, so it must
be confirmed that the oil changes have been made
÷
For more information, refer to DEUTZ TCD 6.1 L6 manual
instruction in chapter «Lubricating Oil System»
6 - Maintenance
500
500
Remove filter Install new filter
147