Air Filter; Changing Engine Oil - Hardi EVRARD ALPHA 2500 Operating And Maintenance Manual

A L P H A 2 5 0 0

Air filter

A indicator is located on the engine air-intake.
If the red signal (1) is fully visible when the engine is off, you must clean the filter
cartridge. Act as follow :
- Undo clip fasteners (2) and take off hood
- Blow out from inside out with dry compressed air (max. 5 bar). In difficult cases,
tap out, taking care not to damage the cartridge.
- After carrying out service work, reset the signal by pressing the button (3) on the
service indicator.
3
1

Changing Engine oil

- Only use quality lube oil (see table of lubricant).
- Ensure that the engine is on level surface
- Allow the engine to warm up (oil temperature approx. 80°c /146°F.)
- Place oil tray under the engine
- Drain oil and replace the oil filter
- Fit oil drain plug with a new gasket and tighten firmly
- Fill with lube oil (see table of lubricant) and check oil level, if necessary top up with oil as far as
the upper bar
I t i s e s s e n t i a l t o u s e t h e m a k e r ' s g e n u i n e o i l f i l t e r
!
Changing Fuel Filter
Draining Fuel Préfilter
1
I t i s e s s e n t i a l t o u s e t h e m a k e r ' s
!
g e n u i n e f u e l f i l t e r c a r t r i d g e
5- 4
677824
CHAPTER
05/01
50
2
250
250
- Replace the fuel filter (1)
- Draining water from the prefilter, by loosing the drain screw (2)
- Unscrew the vent srew to fill up the bowl (3)
- Vent the engine fuel circuit (see chapter below)
2
3
2
M A I N T E N A N C E