Table of Contents
Advertisement
2 - General Safety Instructions
Service and Maintenance
Always reassemble all safety devices or shields immediately after servicing.
After a longer period of standstill, the sprayer must be inspected by a qualified operator. Contact your HARDI dealer for more
information.
Repair work in the main tank must only be carried out by a specialized workshop.
Do not attempt to enter the tank.
Access to the rinsing tank must only take place with the spray boom in transport position, and after it is verified that the
transport locks are engaged.
Regularly check the nuts and bolts for firm seating and re-tighten them as necessary.
If electrical welding is used on the vehicle and on the attached sprayer, disconnect the cable to the alternator and battery
before carrying out electrical welding work on the vehicle. Remove all inflammable or explosive materials from the area to
prevent fire.
Pressure test the spray functions with clean water prior to filling with chemicals.
Refrain from dismounting hoses, pipes, or any equipment, if the sprayer is in operation.
Stay below the maximum speed (rpm) suitable for the PTO shaft.
When replacing spare parts, use suitable tools and personal protective equipment.
Spare parts must at least meet the specified technical requirements of HARDI. This is ensured through the use of genuine
HARDI spare parts.
35
Advertisement
Table of Contents
