Operation Monitoring; Messages Related To Events - Hardi ALPHA EVO II EcoDrive Instruction Book

Operation monitoring

Electronic engine control
The status are displayed by the error lamp. The system monitors the condition of the engine and itself.
• Function test
- Ignition on, error lamp lights up for approx. 2 seconds and then goes out
- Check the error lamp if there is no reaction after switching on the ignition.
• The lamp does not light
- After the lamp test an extinguished lamp indicates an error-free and trouble-free operat-ing state within the scope of
the control possibility.
• Continuous light
– Error in the system.
– Operation continued with restrictions.
– The engine must be checked by a DEUTZ partner.
– If a lamp lights steadily a monitored measuring variable (e.g. coolant temperature, lubricating oil pressure) has left
the permissible value range. Depending on the fault, the engine power may be reduced by the electronic engine
control to protect the engine.
• Flashing
– Serious error in the system.
– Switch off prompt for the operator. Attention: Failure to do so will lead to loss of guarantee!
– The engine has reached switch-off condition.
– Engine forced to run with power reduction to cool the engine, with automatic shut-down if necessary.
– The switch-off process has been accomplished
. – There may be a start lock after engine stop.
– The start lock is deactivated by switching off the system with the ignition key for approx. 2 min.
– If necessary, additional indicator lamps are switched on, e.g. for lubricating oil pressure or the coolant temperature.

Messages related to events

These warning messages appear to indicate that an event has occurred on the machine. They are associated with a beep
sound of 2 seconds.
If the event does not disappear, press on
turned on..
Messages
Beep sound 2 sec.
25
Beep sound 2 sec.
Beep sound 2 sec.
81
Beep sound 2 sec.
button to erase the message. It will appear again when the machine is
Description
Engine pre-heating
Gangway opened
Load of the particle filter too
high
First maintenance (150 hour)
Message
Beep sound 2 sec.
Beep sound 2 sec. AdBlue level low
Beep sound 2 sec.
Beep sound 2 sec.
5 - Operation
Description
Regeneration of the particle filter in
progress
Regular maintenance
every 500 hour
Changing the lubricating oil not
scheduled
99