Table of Contents
Advertisement
5 - Operation
Error messages
When an operating anomaly occurs, an error message is displayed accompanied by a beep sounds continuously. If the
message reads «STOP» the engine must be stopped immediately and the checks carried out.
The message and beep can be cancelled by pressing buttons (2) and (3) for 2 seconds. If the fault has not disappeared the
message will reappear after 30 seconds and the beep will sound after 15 minutes.
Beep sounds cancellation
• Press simultaneously on buttons (2) and (3) to cancel the beep.
Priority alarms
These alarms correspond to serious malfunctions, requiring to stop immediately the engine. They are associated with:
• Engine warning lamp flashes (1 sec.)
• Alarm lamp light up
• Beep sound.i
Messages
Description
Engine overheating
Oil lubricating pressure
Non-priority engine alarms
These alarms concern malfunctions, which do not require to stop the engine immediately. They are associated with:
• Engine warning lamp flashes (1 sec.)
• Alarm lamp light up
• Beep sound
Messages
Description
+
Battery level too low
Hydraulic level too low in the tank
Request for standstill regeneration
Particle filter error
!
Replacing the particle filter
(Ash-load =100%)
100
Turbo-charger Pressure
STOP
Nombre de défauts du moteur
DTC
02
Messages
Description
Affichage code erreur de la
transmission
SD
01
AIR
Clogged air filter
Presence of water in the fuel
FUEL
pre-filter
Hydraulic circuit overheating
1
2
3
4
Advertisement
Table of Contents
