50 Hours Service - Wheel Nuts
Tighten wheel nuts as follows.
Torque wrench setting for mounting wheel hub to rim plate: 490 Nm.
Tightening sequence for wheel nuts: See illustration and tighten in the
numbered order.
μ
ATTENTION! When wheels has been mounted or re-tightened,
the plastic nut covers must be placed on the nuts afterwards.
50 Hours Service - Tyre Pressure
Check the tyre pressure according to the table in "Technical Specifications".
€
DANGER! Never inflate tyres more than to the pressure specified in the table. Over-inflated tyres can explode and
cause severe injuries! See the section "Occasional Maintenance - Change of Tyres".
±
WARNING! If renewing tyres, always use tyres with minimum load index as specified.
50 Hours Service - Air Brakes
The air brakes are checked for leaks by the following procedure:
1. Connect the snap couplers to the tractor. Fill the trailer air tanks.
2. Check for leaks with brakes released.
3. Apply the brake up to full pressure.
4. Check for leaks with brakes applied.
6 - Maintenance
123