Track Width, Axles And Wheels; Altering The Track Width; Turning The Wheel Rim - Hardi NAVIGATOR DELTA FORCE Instruction Book

Hide thumbs Also See for NAVIGATOR DELTA FORCE:
Table of Contents

Advertisement

4 - Sprayer Setup

Track Width, Axles and Wheels

Altering the Track Width

The track gauge of the sprayer can be altered stepless as follows.
1. Measure the current track width (centre right tyre to centre left
tyre). Each side must be extended or retracted half the desired
alteration.
2. Attach the sprayer to tractor and engage tractor parking brake.
3. Place stop wedges in front of and behind right wheel. Jack up left
wheel, support and secure sprayer body.
4. Loosen the counternut at the bolts (A) andthe bolts (A) for left
wheel axle.
5. When having a handbrake, loosen the pointed screw (B)on the
brake operating arm.
6. Extend or retract the axle. A sack barrow and a rod will facilitate the
operation.
7. Lower down the left wheel.Tighten the clamp bolts (A) to a torque
of 250 Nmand lock the bolts with the counternuts.
8. Repeat the procedure on right wheel.
9. Check if the distance from centre tyre to centre of rear frame is equal at right and left side.
10. Retighten bolts and wheel bolts to specified torque after 8 hours of work.
μ
ATTENTION! The wider the track width, the better the stability of the sprayer. HARDI recommends to work with widest
possible track width.
μ
ATTENTION! Depending on configuration of the machine, the track width can be altered in the range from 1500 mm
to 2000 mm (narrow version), or from 1800 mm to 2250 mm (wide version), in combination of above adjustments
and turning of the rims (offset).

Turning the Wheel Rim

Track width can be altered by turning the rims.
After turning the rim around in both sides of the sprayer, the additional
track width can be found in the table below.
÷
The rim centre is offset from the wheel hub by 50 mm inwards at
delivery if not specified otherwise.
μ
ATTENTION! When wheels have been mounted or re-tightened,
the plastic covers must be mounted on the nuts afterwards.
Rim size
Fixing bolts
-
8 pcs.
520/85/R42
10 pcs.
650/85/R42
10 pcs.
520/85/R46
10 pcs.
900/50/R42
10 pcs.
For 5000 and 6000 litre models, only 10-bolt rims are applicable.
80
New track width
222 mm more
226 mm more
226 mm more
230 mm more
230 mm more

Advertisement

Table of Contents
loading

Table of Contents