Installing The M.2 Sata Ssd; Figure 68: Installing The Antennas And Connecting The Gps Antenna (Via Emio-8570 ); Figure 69: Installing The Sata M.2 Ssd Module - VIA Technologies EPIA-M930 User Manual

VIA EPIA-M930 User Manual
Step 3
To assemble the GPS Main antenna, place the washer over the threaded end of the antenna cable, add the
washer, fasten it with the nut, and install the external antenna. Connect the other end of the GPS antenna
cable to the micro-RF connector (I-PEX), labeled "G" on the VIA EMIO-8570 module.

Figure 68: Installing the antennas and connecting the GPS antenna (VIA EMIO-8570 )

A.4 Installing the M.2 SATA SSD
Step 1
Insert the standoff included in M.2 screw pack into the appropriate hole on the VIA EPIA-M930 board that
matches the length of the M.2 SATA SSD being installed. Align the notch on the M.2 SATA SSD with the
counterpart on the M2_B_2280_1 slot. Then insert the drive at a 30° angle. Align the mounting hole on the
M.2 SATA SSD with the mounting hole on the standoff, and then secure the drive in place with one of the
screws included in the M.2 screw pack.
2
1
3

Figure 69: Installing the SATA M.2 SSD module

53