6.7.2.1 SATA Configuration
This SATA Configuration screen shows options for configuring the SATA devices.
Advanced
SATA Configuration
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Port 0
SATA Device Type
Serial ATA Port 1
Port 1
SATA Device Type
Figure 58: Illustration of the SATA Configuration screen
•
SATA Controllers
−
Enabled or disable the SATA controllers.
•
SATA Mode
−
Select the SATA Mode used.
Serial ATA Port 0
This is the settings for the onboard M2_1 slot.
•
Serial Port 0
−
Provides information if the port is occupied or not.
•
Port 0
−
Enable or disable the mSATA drive.
•
SATA Device Type
−
Select the type of storage installed.
Serial ATA Port 1
This is the settings for the onboard SATA1 connector.
•
Serial Port 1
−
Provides information if the port is occupied or not.
•
Port 1
−
Enable or disable the onboard SATA storage port.
•
SATA Device Type
−
Select the type of storage installed.
Aptio Setup - AMI
[Enabled]
[AHCI]
Empty
[Enabled]
[Hard Disk Drive]
Empty
[Enabled]
[Hard Disk Drive]
Version 2.22.1282 Copyright (C) 2022 AMI
VIA EPIA-M930 User Manual
Enable/Disable SATA Device.
: Select Screen
: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
44