Setting The Actual Value Potentiometer For C-Arm Orbital Movement - Siemens SIREMOBIL Iso-C Service Instructions Manual

Replacing boards / replacing components

Setting the actual value potentiometer for C-arm orbital movement

NOTE
•
The C-arm is in the -95° position. See note.
•
Loosen the Allen screw of the large pulley (2/Fig. 21).
•
Using a screwdriver, turn the actual value potentiometer counterclockwise to the end
stop (Fig. 22).
•
Then turn it clockwise two turns.
•
Retighten the Allen screw of the large pulley.
•
Perform the mechanical settings according to the Startup Instructions, Chapter 6.
Siemens AG
Medical Solutions
Prior to setting the actual value potentiometer the C-arm must be
in the orbital -95° position (The orbital limit switch on the tube
side is actuated). If this is not yet the case, loosen the Allen screw
of the large pulley before moving the C-arm (2/Fig. 21) to prevent
overturning of the actual value potentiometer.
SPR2-230.061.01
Rev. 13
Page 45 of 48
12.04 CS PS 24
6 - 45
6
SIREMOBIL Iso-C
System Manual