5 - 12
•
Select "5. CLOSED POSITION" on the service PC and click on "Execute".
•
Close the status window by clicking on the OK button.
•
For the query "Do you want to reset the Unit", click "NO".
•
Select "8. Init Off & Store Positions" on the service PC and click on "Execute" .
•
Close the status window by clicking on the OK button.
•
For the query "Do you want to reset the Unit", click "Yes".
•
Switch the SIREMOBIL Iso-C OFF and ON.
•
Check the X-Iris again in survey format and zoom format. The collimator blades must still
be visible on the edge of the image. If necessary, repeat the adjustment.
•
Return to the main menu on the service PC with the ESC key.
•
Select the Data, Backup... menu.
•
Select Parameter in the backup window.
•
Click on "Backup".
•
At "Remarks for Parameter" enter "X-Iris set".
•
Click on "OK" . The new position values for the collimator will be stored on the disk.
•
Return to the main menu with the ESC key.
Collimator, slot diaphragm
Prerequisites
•
Camera rotation has been adjusted correctly.
•
Image reversal functions are disabled.
•
The "SLOT DIAPHRAGM", "TYPE OF DIAPHRAGM" parameter has been programmed
for "DISPLAY YES".
Adjustment
•
Connect the service PC to the serial service interface.
•
Start the service program.
•
Select the Adjustment, Calibrations...menu.
•
Respond to the query with yes.
•
In the Combo box "Function Groups:" select "Slot Diaphragm".
•
In the window "Available Functions:" select "Disable circle mask" and click "Execute.
The circle mask of the Memoskop is switched off.
•
Close the status window by clicking on the OK button.
•
Respond to the query "Do you want to reset the unit" by clicking "No" .
•
In the window "Available Functions:" select "Init" and the "Execute".
•
Close the status window by clicking on the OK button.
•
Respond to the query "Do you want to reset the unit" by clicking "No" .
SIREMOBIL Iso-C
System Manual
Adjustments / Programs
SPR2-230.061.01
Rev. 13
12.04
Page 12 of 30
CS PS 24
5
5
5
Siemens AG
Medical Solutions