Mercedes-Benz Metris 2021 Operating Instructions Manual page 96

Table of Contents

Advertisement

94
Climate control
with rear climate control, the temperature for the
rear compartment can also be set. Each set tem‐
perature is automatically maintained at a con‐
stant level.
To increase or decrease: turn the corre‐
#
sponding temperature control counter-clock‐
wise or clockwise (
page 91).
/
The control panel display shows the set tem‐
perature for the left or right side at the
respective edge of the display.
Vehicles with rear climate control: press the /
button to set the temperature for the rear com‐
partment. When the indicator lamp on the button
flashes, you can set the temperature.
Switching the synchronization function
on/off
Requirements:
The climate control system has been
R
switched on (
page 91).
/
3-zone automatic climate control
The temperature can be set centrally using the
synchronization function. The temperature set‐
ting for the driver's side will then be adopted for
the front passenger side and, in vehicles with rear
climate control, the rear compartment as well.
Press the 0 button.
#
When the indicator lamp on the 0 button
lights up, the function is switched on. The dis‐
play will then show the temperature set on
the driver's side for the front passenger side.
The synchronization function will switch off if the
temperature setting for the front passenger side
or for the rear compartment is altered. The indi‐
cator lamp on the 0 button will go out.
Defrosting the windshield
Heating or dual-zone automatic climate con‐
trol
You can use the following settings to defrost the
windshield and remove condensation from the
windshield and the front side windows from the
inside. Select the following settings only for as
long as it takes for the windshield to be clear.
Switch on climate control (
#
If necessary, switch on the rear window
#
heater (
page 95).
/
If the windows are fogged up: switch off air-
#
recirculation mode (
/
#
#
#
#
3-zone automatic climate control
You can use the following settings to defrost the
windshield and remove condensation from the
windshield and the front side windows from the
inside. Select the following settings only for as
long as it takes for the windshield to be clear.
#
#
#
When you enable automatic mode, the "Defrost
windshield" function will switch off automatically.
When you switch off the "Defrost windshield"
function, the previous settings for automatic cli‐
mate control will be applied again.
Note the following exceptions:
R
R
Switching air-recirculation mode on/off
Dual-zone or 3-zone automatic climate con‐
trol
When air-recirculation mode is switched on, the
windows may fog up more quickly. Switch on air-
recirculation mode only briefly.
#
page 91).
/
page 94).
Turn the temperature control and airflow con‐
trol to the z position (
/
Select the ¯ position for air distribution
(
page 93).
/
Only the indicator lamp on the ¯ button
will light up.
Vehicles with heating: close the center air
vent (
page 95).
/
Vehicles with air conditioning: switch on the
"Cooling with air dehumidification" function
(
page 92).
/
Switch on climate control (
/
If necessary, switch on the rear window
heater (
page 95).
/
Press the ¬ button.
The temperature, airflow and air distribution
will be regulated automatically. Air-recircula‐
tion mode will be deactivated.
Air-recirculation mode will remain switched
off.
If the A/C function has been automatically
activated, it will remain active.
Press the h button.
When the indicator lamp on the h button
lights up, air-recirculation mode is switched
on.
page 90).
page 91).

Advertisement

Table of Contents
loading

Table of Contents