Tool holder in the cargo compartment
Removing the tool and the jack
Tool holder in the cargo compartment on the
right-hand side of the vehicle (example: Cargo
Van)
Remove clamping strap 2.
#
Remove cover
1
of the tool holder.
#
Carefully pull the vehicle tool kit and jack out
#
of the tool holder.
Storing the tool and the jack
Before storing, wind the jack to the fully
#
closed position and place it so that the hand‐
wheel is facing forwards and the plate is
facing inwards.
Place the jack and vehicle tool kit into the
#
tool holder.
Fit the cover
1
of the tool holder.
#
Tighten clamping strap 2.
#
Removing the jack from the tool holder
Holder for jack in the cargo compartment on the
right-hand side of the vehicle (for example, Cargo
Van)
Remove clamping strap 1.
#
Pull jack
2
out of the upper holder and from
#
lower bracket 3.
The vehicle tool bag or tire-change tool kit is
#
in the seat base of the left front seat
(
page 201).
/
Breakdown assistance 203
Stowing the jack
Before stowing, wind the jack as far as it will
#
go and position it with the handwheel facing
down and the plate facing inwards.
Place jack
2
onto lower bracket 3.
#
Press jack
2
into the upper holder and fas‐
#
ten clamping strap 1.
The jack is secured.