Table of Contents
Advertisement
84
Light and vision
Pull the connector off the bulb mount of tail
#
lamp 2.
Installing the tail lamp
Push the connector into the bulb mount of tail
#
lamp 2.
Push tail lamp
2
onto bolts
#
and press it against the vehicle.
Tighten two side screws 1.
#
Standard tail lamp
Unscrew three screws
1
#
mount
2
from the tail lamp.
Bulb mount
3
Turn signal light, brake light, tail light, stand‐
ing lamps
4
Backing up light
5
Rear fog lamp (only on the driver's side)
Remove the tail lamp.
#
Gently turn the bulb counter-clockwise and
#
take it out of the socket.
Push the new bulb into the socket and turn it
#
clockwise to screw it in.
Insert bulb mount
2
into the tail lamp and
#
tighten all three screws 1.
Install the tail lamp.
#
Replacing interior light bulbs
Replacing light sources in the interior
Requirements:
R
R
3
from the side
R
R
Rear compartment and cargo compartment
lamps
and remove bulb
#
#
#
#
#
#
Additional interior and surround lighting
Depending on the equipment, replacing the light
sources as described here applies to the follow‐
ing lamps:
R
R
R
The interior lighting has been switched off.
Rear compartment and cargo compart‐
ment lamp: you require a T10 6W xenon light
source.
Interior and surround lighting: you require
a W 5 W light source.
Signal and ambient lamp in the tailgate:
you require a W 5 W light source.
Push in the catch spring of lens
suitable object, e.g. a screwdriver, and then
pry off the lens with the lamp housing.
Push the lugs of socket
2
Remove light source
3
from the lamp hous‐
ing.
Insert the new light source.
Position the lens on the lamp housing and
engage it.
Align the lens with the lamp housing and
engage it.
The sun visor mirror lamp
The ambient lamp at the bottom of the front
door
The ambient lamp on the inside of the tailgate
1
with a
inwards.
Advertisement
Table of Contents
