Table of Contents
Advertisement
Settings menu
Requirements:
The vehicle is stationary.
R
Use the buttons on the instrument cluster to
operate the on-board computer.
Introduction
To display the Settings menu: use the È
#
button to select the
Settings
Use the 3 button to scroll through the menu and
select its submenus or functions successively.
If you press the È button in a submenu, the sub‐
menu or function will be exited without the set‐
ting being adopted.
Depending on the equipment, the following is
possible:
Setting the language of the display messages
R
and displays
®
Switching ESP
on/off (
R
Setting the sensitivity of the rain sensor
R
Switching ATTENTION ASSIST on/off
R
(
page 128)
/
Setting the unit for distance, consumption
R
and speed displays
Setting the time and date
R
To reset to factory settings: turn the key to
#
position 1 in the ignition lock and, in the
Settings
menu, press and hold the 3 button
for at least five seconds.
For safety reasons, not all functions will be reset.
Setting the display language
Press 3 to select the
Language:
#
The display will show the current language
selection.
Use the f or g button to select a language.
#
Press the 3 button to confirm.
#
The next submenu will be shown on the dis‐
play.
Setting the sensitivity of the rain sensor
Press the 3 button to select the
#
sor:
submenu.
The display will show the current sensitivity
setting.
Instrument cluster and on-board computer 143
#
#
menu.
%
Selecting the permanent display function
For all countries except the United Kingdom:
Using the
switch the header of the display between outside
temperature and speed (additional speedometer).
When the display shows the speed in the header,
the outside temperature is shown with the odom‐
eters.
The additional speedometer unit in the header is
page 111, 112)
/
always the inverse of the speedometer unit.
#
#
#
Selecting the unit of measurement for dis‐
tance
You can select whether the display shows some
information in miles or kilometers.
#
submenu.
#
#
Rain Sen-
Use the f or g button to select the Low,
Standard
or
High
setting.
This setting controls the rain sensor's sensi‐
tivity to precipitation. This results in the wind‐
shield wipers wiping more or less often at the
same precipitation intensity.
Press the 3 button to confirm.
The next submenu will be shown on the dis‐
play.
You can find further information under "Wind‐
shield wipers" (
page 85).
/
Permanent Display:
function, you can
Press the 3 button to select the
Display:
submenu.
The display will show the current setting.
Change the setting by pressing the f or g
button.
Press the 3 button to confirm.
The next submenu will be shown on the dis‐
play.
Press the 3 button to select the
Unit:
submenu.
The display will show the current setting.
Change the setting by pressing the f or g
button.
Press the 3 button to confirm.
The display will show the next submenu or
the
Settings
menu again.
The selected unit of measurement for dis‐
tance applies to the following displays:
Digital speedometer
R
Total distance and trip distance
R
Trip computer
R
Range
R
Current consumption
R
Permanent
Distance
Advertisement
Table of Contents
