Installing The Fuses - Toro Groundsmaster 4000 Series Installation Instructions Manual

Figure 39
1. 12-socket connector
(machine wire harness)
2. Cap
2. Plug the 12-pin connector of the console
harness into the 12-socket connector of the
machine wire harness
7

Installing the Fuses

Parts needed for this procedure:
1 Fuse (10 A)
1 Fuse (15 A)
Removing the Electrical Cover
Machines with a Roll Bar
At the floor along right side of the operator's seat,
remove the 2 socket-head screws and 2 washers that
secure the controller cover to the electrical-component
mount, and remove the cover
g351027
3. 12-pin connector (console
harness)
(Figure 39).
(Figure 40).
1. Electrical cover
2. Socket-head screw
Removing the Electrical Cover
Machines with a Cab
At the floor along right side of the operator's seat,
remove the 2 socket-head screws that secure the
controller cover to the electrical-component mount,
and remove the cover
19
Figure 40
3. Washer
4. Clip nut
(electrical-component
mount)
(Figure 41).
g351012
g351093