Toro Groundsmaster 4000 Series Installation Instructions Manual page 9

Figure 14
1. 6-socket connector
(labeled H LH or
EADLIGHT
H RH—machine
EADLIGHT
wire harness)
2. Cap
3. If assembled, remove the locknut (12 mm) and
lock washer (12 mm) from the capscrew in the
headlight bracket.
4. Assemble the capscrew (12 mm) to the light
mount (Figure 15) with the locknut (12 mm) and
lock washer (12 mm).
g350820
3. Headlight
Right headlight shown.
1. Headlight
2. Light mount (machines
with a roll bar)
5. Tighten the locknut and capscrew.
6. Bundle the excess wire harness and secure it to
the chassis with a cable tie.
7. Repeat steps 2
at the other side of the machine.
9
Figure 15
3. Lock washer
4. Locknut
through 5 for the other headlight
g350531