Toro Groundsmaster 4000 Series Installation Instructions Manual page 7

1. Capscrew (1/2 x 4-1/2
inches)
2. Floor panel
3. Thin washer (1/2 x 1-3/8
inch)
Installing the Light Mounts to the
Machine
Machines with a Roll Bar
1. Assemble the light mount to the floor panel and
frame of the machine with the capscrew (1/2 x
4-1/2 inches), thin washer (1/2 x 1-3/8 inch),
thick washer (1/2 x 2-1/4 x 3/8 inch), and flange
locknut (1/2 inch) that you removed in
the Floor Panel Hardware (page
Figure 10
4. Flange locknut (1/2 inch)
5. Thick washer (1/2 x 2-1/4
x 3/8 inch)
Removing
6).
g350418
1. Capscrew (1/2 x 4-1/2
inches)
2. Thin washer (1/2 x 1-3/8
inch)
3. Light mount (machines
with a cab)
2. Torque locknut and capscrew and locknut to 91
to 113 N∙m (67 to 83 ft-lb).
3. Repeat steps
other side of the machine.
Assembling the Headlights
Machines with a Cab
Important:
Ensure that you assemble the
headlight marked left and the left light mount,
and the headlight marked right and the right light
mount.
1. If assembled, remove the locknut (12 mm) and
lock washer (12 mm) from the capscrew in the
headlight bracket.
2. Align the light to the light mount as follows:
7
Figure 11
4. Thick washer (1/2 x 2-1/4
x 3/8 inch)
5. Flange locknut (1/2 inch)
1 and 2 for the light mount at the
g350530