Toro Groundsmaster 4000 Series Installation Instructions Manual page 12

Preparing the Steering Cover and
Routing the Control Harness
1. Remove the boot from the steering cover, and
slide the boot up
Figure 19
1. Boot
2. Flange-head screws
2. Remove the 4 flange-head screws that secure
the steering cover to the cover mounts, and lift
the cover (Figure
3. Grind a notch in the steering cover as show in
Figure 20.
(Figure 19).
3. Steering cover
19).
g350969
1. Notch (steering cover)
2. 6 mm (1/4 inch)
4. Align the 12-pin connector end of the control
harness through notch in the steering cover
(Figure 21).
12
Figure 20
3. 11 mm (7/16 inch)
g350968