Toro Groundsmaster 4000 Series Installation Instructions Manual page 8

•
Groundsmaster 4010 Machines: Use the
outside light-mount hole.
•
Groundsmaster 4110 Machines: Use the
inside light-mount hole.
Figure 12
Right headlight shown.
1. Capscrew (headlight)
2. Outside light-mount hole
(Groundsmaster GM4010
machines)
3. Inside light mount hole
(Groundsmaster GM4110
machines)
3. Assemble the capscrew (12 mm) to the light
mount (Figure 12) with the locknut (12 mm) and
lock washer (12 mm).
4. Tighten the locknut and capscrew.
5. Repeat steps 1 through
light mount for the other side of the machine.
g350532
4. Lock washer
5. Locknut
4 for the headlight and
Installing the Headlights
Machines with a Roll Bar
Important:
Ensure that you assemble the
headlight marked left at the left side of the
machine, and the headlight marked right at the
right side of the machine.
1. Remove the cable tie securing the 6-socket
connector labeled H
6-socket connector labeled H
the machine wire harness to the chassis of the
machine (Figure
2. Remove the cap from the 6-socket connector
labeled H
EADLIGHT
labeled H
EADLIGHT
harness, and plug the connector into the
headlight (Figure
8
LH and the
EADLIGHT
EADLIGHT
13).
Figure 13
LH or the 6-socket connector
RH of the machine wire
14).
RH of
g350877