Toro Groundsmaster 4000 Series Installation Instructions Manual page 27

7. Plug the 4-pin connector labeled LH Rear Lights
of the left taillight harness into the 4-socket
connector labeled LH R
wire harness (Figure
Routing and Connecting the Right
Taillight
1. Route the 4-socket connector labeled RH R
L of the machine wire harness under the left
IGHT
frame rail and forward
Figure 59
1. Magnetic harness anchor
2. At the inboard side of the frame rail, remove
the cap from the 4-socket connector labeled RH
R L of the machine wire harness
EAR IGHT
60).
L of the machine
EAR IGHT
58).
EAR
(Figure 59).
(Figure
1. Cap
g351427
2. 4-socket connector
(labeled RH R
L —machine wire
IGHT
harness)
3. Plug the 4-pin connector labeled RH Rear
Lights of right taillight harness into the 4-socket
connector labeled RH R
machine wire harness
g351445
Important:
routed away from the exhaust pipe.
4. Close and latch the hood.
27
Figure 60
3. 4-pin connector (labeled
RH Rear Lights—right
taillight harness)
EAR
L
EAR IGHT
(Figure 60).
Ensure that the harnesses are
g350907
of the