Toro Groundsmaster 4000 Series Installation Instructions Manual page 11

5
Installing the Control
Console
Parts needed for this procedure:
1 Console harness
1 Cap plug
1 Fuse mount plate
1 Clip nut (#10)
1 Flasher
1 Flange head screw (#10 x 3/8 inch)
1 Cable tie
2 Bracket mount
8 Clip nut (1/4 inch)
1 Switch mount
1 Multi-function switch
1 Switch clip (thick)
1 Switch clip (thin)
3 Switch plug
1 Rocker switch
2 Knob
1 Fuse cover
2 Bolt retainer
4 Carriage bolt (1/4 x 2 inches)
4 Flange locknuts
2 Cable ties
2 Push-in fastener
4 Flange-heads screw (1/4 x 3/4 inch)
Installing the Console Harness
Connector Plug
1. Disconnect the single-pin connector from the
single-socket connector labeled NA/EU M
S (Figure
ELECTOR
1. Cap plug
2. Single-socket connector
(labeled NA/EU M
S )
ELECTOR
2. Plug the single-pin connector and the
single-socket connector into the cap plug
18).
11
18).
Figure 18
3. Single-pin connector
ODE
ODE
g350773
(Figure