Maintenance - Toro Groundsmaster 4000 Series Installation Instructions Manual

Maintenance

Servicing the Fuses
Replacing a Fuse Block Fuse
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units, shut off
the engine, and remove the key.
2. Remove the electrical cover, refer to
the Electrical Cover (page 19)
Electrical Cover (page
3. Replace the open fuse.
Fuse-block slot Protected Circuits
A3 EU light kit power
A4 Road light kit
Figure 67
1. Fuse (10 A) and fuse-block
slot A3
4. Install the electrical cover; refer to
the Electrical Cover (page 20)
Electrical Cover (page
Replacing a Taillight Fuse
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units, shut off
the engine, and remove the key.
2. Unlatch and open the hood.
3. Remove the cap from the in-line fuse holder
(Figure 68).
Removing
or Removing the
19).
Fuse Rating
10 A
15 A
g351014
2. Fuse (15 A) and fuse-block
slot A4
Installing
or Installing the
20).
1. Cap
2. Fuse
4. Replace the fuse; refer to the Fuse Table.
Fuse Table
Left taillight Protected Circuits
harness
Labeled LH R Taillights
EAR
L (left taillight
IGHTS
harness)
Labeled B Brake lights
RAKE
L F
IGHT USE
Left taillight Protected Circuits
harness
Labeled RH R Taillights
EAR
L (right
IGHTS
taillight harness)
Labeled B Brake lights
RAKE
L F
IGHT USE
5. Install the cap onto the fuse holder
6. Close and latch the hood.
30
Figure 68
3. In-line fuse holder
Fuse Rating
5 A
5 A
Fuse Rating
5 A
5 A
(Figure
g350865
68).