3-12.Burst Level Adjustment; 3-13.Monitor Out Level Adjustment - Panasonic AJ-D610WBP Service Manual

3-12. Burst Level Adjustment
<For NTSC>
BOARD ENCODER
TP CAM OUT
ADJUST VR203[BURST LVL]
MODE CAMERA BAR
M. EQ.
Vector Scope
SPEC. Burst Level = 75%
1. Connect a Waveform Monitor to the CAM OUT
and adjust VR203 so that the Burst level is in the
specification.
<For PAL>
BOARD ENCODER
TP CAM OUT
ADJUST VR203[BURST LVL]
VR207[BURST PHASE]
MODE CAMERA BAR
M. EQ. Vector Scope
SPEC. Burst Level : 75%
Burst phase: 90 Degrees
1. Connect a Waveform Monitor to the CAM OUT
and adjust VR203 and VR207 so that the Burst
level is in the specification.
<Note>
If the Carrier Balance is incorrect after adjustment, repeat
3-8. Carrier Balance Adjustment (VR206, VR209).
3-13. Monitor OUT Level
BOARD
ADJUST
MODE
M. EQ.
SPEC.
Menu Setting
1. Set [MENU] switch to SET while pressing [SHIFT],
[+], and [-] buttons on the operation panel.
2. Set the menu as shown below.
3. Connect a Waveform Monitor to the VIDEO OUT
and adjust VR102 so that the level A is in the
specification.
75%
<NTSC>
<PAL>
4. Return the MENU setting as follows.
ELE- 17
Adjustment
ENCODER
TP VIDEO OUT
VR102[MON_LVL],EVR
CAMERA BAR
WFM
NTSC : A = 714mV+/-15mV
PAL : A = 700mV+/-15mV
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER
OFF
A
ON