Blooming Adjustment; Carrier Reduce Adjustment - Panasonic AJ-D610WBP Service Manual

2-7. Blooming Adjustment

BOARD CCD PULSE
TP CAM OUT
VR 8 [SUB R] (CCD PULSE)
ADJUST VR 9 [SUB G] (CCD PULSE)
VR10[SUB B] (CCD PULSE)
F NUMBER Open
CHART Halogen Light
M. EQ. Monitor
SPEC. No Blooming
1. Shoot a 500W halogen light and set the zoom
position so that the halogen light size is
approximately 1/10 of the vertical direction of the
monitor as shown in figure.
2. Confirm that blooming is not appeared at the any
position of the monitor screen as shown in figure.
3. If blooming is appeared, adjust VR8, 9, 10 so that
the blooming is disappeared.
If blooming color is RED, adjust VR8.
If blooming color is GREEN, adjust VR9.
If blooming color is BLUE, adjust VR10.
Mo n i t o r
B l o om in g
1 / 1 0 V
ELE- 6

2-8. Carrier Reduce Adjustment

PRE AMP
BOARD
TP103 [R-SH]
TP203 [G-SH]
TP
TP303 [B-SH]
VC101 [R CRR]
VC201 [G CRR]
ADJUST
VC301 [B CRR]
F11
F NUMBER
CHART
Gray Scale (2000 +/- 50 Lux)
M. EQ. Oscilloscope
A = Minimum level
SPEC.
1. Adjust the VC101 so that the level A at the TP103
is minimum level.
2. Adjust the VC201 so that the level A at the TP203
is minimum level.
3. Adjust the VC301 so that the level A at the TP303
is minimum level.
A
A