Software Version-Up Procedures - Panasonic AJ-D610WBP Service Manual

15-4. Software Version-up Procedure
15-4-1. Version-up method for IC6201 (CAM_SYS P.C.Board)
1. Connect cable between USER BOARD connector on FLASH1 and Connector P6104 on CAM_SYS P.C.Board
through connection board.
2. Connect D-SUB 25-pin – 9-pin Cable (Straight type) between COM port (1 or 2) on PC and RS-232C connector
on FLASH 1.
3. Set SW201 [LOAD] on CAM_SYS P.C.Board to "ON". (See figure 4-1)
4. Turn on the power of Camcorder and then boot up PC (with Windows
5. Copy all files of Data writing software ("Flash 1 for windows": Included with FLASH 1) to hard drive on PC.
6. Install "Flash 1 for windows software" to PC.
7. Copy version-up data (xxxx.mot format file) to same directory of F1win.exe.
D-SUB 25pin-9pin
PC
Fig. 4-1
8. Execute "F1win.exe (Flash 1 for windows application)" and then set parameters as shown in figure 4-2.
Flat Cable(VWJ20E5500L00)
(Include with VFK1304A)
Cable
VFK1725
(FLASHI)
Fig. 4-2 Flash 1 for windows main window

VFK1726
Camera Recorder
Initial Bit Rate
Maximum Bit Rate : 9600bps
CPU Type
COM Port
Verify
Language
INF-33
).
CAM_SYS Board
: 9600bps
: H8/3048F
: COM1 or COM2
: Check mark ON
: English
P6104
ON
SW201