Setup Level Setting - Panasonic AJ-D610WBP Service Manual

3-7. Setup Level Setting

CAM SYS
BOARD
VIDEO OUT, CAM OUT
TP
EVR
ADJUST
CAMERA BAR
MODE
WFM Monitor
M. EQ.
Distribution (Setup Level)
NTSC = 7.5% or 7.5%A
SPEC.
PAL, Japan = 0%
Menu Setting
1. Set [MENU] switch to SET while pressing [SHIFT],
[+], and [-] buttons on the operation panel.
2. Set the menu as shown below.
PAGE : SERVICE ADJ.1/2
ECU CONNECT : EVR
EVR Setting
3. Set EVR as follows to set the VIDEO OUT to the
COMPONENT Y OUT.
1)COM:[1E] DATA:[27] ADR:[00] [Enter]
2)COM:[0C] DATA:[20] ADR:[1A] [Enter]
4. Set EVR as follows.
[ 0% Setup] COM:[1D] DATA:[02]
[7.5% Setup] COM:[1D] DATA:[04]
[7.5%A Setup] COM:[1D] DATA:[08]
5. Set EVR and confirm that the VIDEO OUT, CAM
OUT is following setting.
COM:[1E] DATA:[02] ADR:[00]
The setting of setup level
setting
VIDEO OUT
Output in
(Component
out)
CAM OUT
Output in
(Composite
out)
[Enter]
[Enter]
[Enter]
[Enter]
0% 7.5% 7.5%A
setting setting
Output in Output in
0% 7.5%
Output in Output in
0% 7.5% 7.5%
<Note>
Especially, in setting of 7.5%A, be careful of setup
level.
0%
ELE- 14
7.5%
0%, 7.5%A
V I D E O O U T S i g n a ls
7.5%, 7.5%A
0%
C A M O U T S i g n a ls